- Subscribe to RSS Feed
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
A60 motherboar d heatsink screw torque
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Flag for a Moderator
11-06-2009 06:15 PM
I am replacing a motherboard on A60-S159. The heatsink/fan assembly has 5 spring loaded screws. Is there a recommended torque value for these screws ? I am concerned I will tighten them too tight.
Re: A60 motherboar d heatsink screw torque
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Flag for a Moderator
11-06-2009 06:54 PM
750 foot pounds of torque each or tighten them until they break and then back them off a quarter turn.
Seriously though, normally they bottom out and allow the springs to set the tension.
If you don't bother to post your COMPLETE model number it's very difficult to assist you. Please post in complete sentences with punctuation, capitals, and correct spelling. Toshiba does NOT provide any direct support in these forums. All support is User to User in their spare time.

Feedback